Click Next when the Installation Complete screen is displayed. If you are running Windows 7 or Windows 8, the following Windows Security dialog may be displayed. Click install to continue.ħ. Once you have complied with the requirements of the warning message, click OK to continue.Ħ. Carefully read the warning message, and disconnect all RP1210 adapters to which your laptop or PC might be connected prior to proceeding with the installation.ĥ. Read all the all information on this screen, then click I AgreeĤ. The Welcome to INlINE7 Setup screen is displayed and please carefully read the information to follow the recommendations. INLINE 7 communicates with your PC and is designed for future capability with mobile products.īellowing instructions how to set up the Cummins INLINE 7 Data Link Adapter:ġ.Extract zip and Double-click on the setup.exe file to run the install.Ģ.

INLINE 7 supports USB, WiFi and Bluetooth technologies in a single device. The solution is this, connect, then scan to diagnostic connector but not to USB, open the Cummins insite and push connect, when the Insite begin to connect. Here is what the work orders show before and after:Įngine Distance: 2896763.Cummins INLINE 7 Data Link Adapter with Cummins Insite 8.5/8.7 Software diagnostic tool has a faster processor, more robust algorithms, larger memory buffers and more sophisticated filtering than previous models while simultaneously accessing multiple vehicle data channels. Functionality Levels Here is a helpful chart that shows the different Insite programs and their corresponding features. Please post the before and after calibration used. To use Cummins Insite you’re going to need an RP1210 adapter (ex: Cummins Inline 6 or 7, DG Technologies DP5A, Nexiq USBLink2, etc.) and the corresponding connection cables. May be a parameter didnt transfer over, it happens. Have you tried it out, speedo/tach, cruise switch, fast idle? See if they work.

If it is there it is more likely a comunication error. The operator can adjust the idle speed in 25 RPM increments if an OEM-supplied idle adjustment switch is installed. Try check the J1939 parameters, compare your old WO in insite to the features and parameters in your ECM now, seems like a communication error, ECM not telling Dash ECU the info.Īlso check in 'trip information' under all trips (cumulative) your mileage should show there. This parameter is used to set an incremental change in acceleration or deceleration. If you did add mileage to the ECM distance offset in features and parameters, and it didnt show on your odometer, your problem probably isnt with the mileage in the ECM.

Odometer setting cummins insite