PC1 - has 9 SSDs/HDDs (5 connected to the onboard SATA and 4 to an add-on SATA board). PC 1 - the PC to be used to monitor the other 2 PCs. I understand that it doesn't turn on until the GPU gets up to 60C, but thought it odd that it doesn't even show up to HWINFO until it turns on. I intend to monitor 2 PCs (specifically AiO pump and fan rpm and coolant temperature, CPU temperature, drve S.M.A.R.T.

Probably due more to flash than the card. I really only play online games and probably didn't need to upgrade the card, but on occasion, the games were getting glitchy. Now I just like knowing how hard it's running. When I was ripping using other software that used the video card, I'd monitor the temp and whatnot. Anyone have a fix for this that doesn't require running software in the background to force a different fan curve? I used to care about my card/temp when I was converting videos, it used cuda cores, but I have been using handbrake for quite some time now as I get better results. Now that I have the EVGA GTX 960 SC (02G-P4-2962-KR), HWINFO doesn't show the fan until it has kicked on by straining it and pushing up to 60C. I had a MSI 650 Ti card and I was able to see the fan RPM speed and percent all the time. to 3510 RPM, etc).I'm not a gamer by any means, but I do like seeing info about my PC using rainmeter with the HWINFO plugin. Check with current HWiNFO32 what rates do you have and how would you like to change the logic (like - change step 4. I can offer to make a simple change to the table, so now the question: what kind of problems are you experiencing with the default fan control logic ? As I have been told, it seems that the fans begin too late to spin faster (temperature too high already) ? If this is the case I could change a single entry in the table to force a higher spin rate at lower temperature. The resulting fan RPM values are not exact and it seems that when trying to force the fan > 3500 RPM it won't rotate faster. Note that the temperature values are not in Celsius as I already mentioned, but in duty cycles of a PWM pin input. So after checking a dump from 8740w, the pre-defined look-up table looks like this: And this is something I don't want to be responsible for.

I can think about adding some simple option to fix an issue, but giving the users too much control over the Temperature/Fan LUT (Look-Up Table) would be a bit complicated to implement and if not properly configured could cause damage.

Hwinfo how to control fan